Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Transmission
- Coupling and power shafts
General information
Coupling - the general information and check of a condition of components
Removal and installation of the main cylinder of coupling
Removal and installation of the executive cylinder of coupling
Air removal from a hydraulic path of a drive of switching off of coupling
Removal, check of a condition and installation of components of assembly of coupling
Removal, check of a condition and installation of the vyzhimny bearing and lever of switching off of coupling
Adjustment of a pedal of coupling
Check of serviceability of functioning and replacement of the sensor switch of disconnection of a chain of a starter
Power shafts - the general information and condition check
Removal and installation of power shafts
Check of a condition and replacement of assembly of the basic bearing
Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
General information
The present Head is devoted to the components located between a back part of the engine and forward (leading) wheels of the car. According to the destination considered components can be broken into two categories: coupling and power shafts. Descriptions of a design and a principle of action of each of separate knots, and also procedures of check of a condition, removal, dismantling and regenerative repair of components entering into both groups are provided in below-mentioned Sections.
As the most part of procedures described in the present Chapter is made under the car, it is necessary to give special attention to reliability of fixing of the last in the lifted situation. |
|
