The device, service, Nissan Maxima QX repair - Check of a condition and replacement of assembly of the basic bearing//Maxim's Nissan (from 1993 g) accessories-sale.ru

Nissan Maxima QX

since 1993 of release

Repair and car operation


Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Transmission
- Coupling and power shafts
   General information
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal, check of a condition and installation of components of assembly of coupling
   Removal, check of a condition and installation of the vyzhimny bearing and lever of switching off of coupling
   Adjustment of a pedal of coupling
   Check of serviceability of functioning and replacement of the sensor switch of disconnection of a chain of a starter
   Power shafts - the general information and condition check
   Removal and installation of power shafts
   Check of a condition and replacement of assembly of the basic bearing
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
 9a1e70e9


Check of a condition and replacement of assembly of the basic bearing

 Procedure belongs only to assembly of the right power shaft.


 PERFORMANCE ORDER

1. Remove assembly of the right power shaft (see. Section Removal and installation of power shafts).
2. Manually check smoothness and noiselessness of rotation of the basic bearing.
3. It is necessary to charge performance of replacement of the failed bearing to specialists of car repair shop, prepare a remnabor consisting of replaceable knot with three boots.
4. Establish assembly of a power shaft with the new basic bearing pressed on it on the regular place (see. Section Removal and installation of power shafts).