The device, service, Nissan Maxima QX repair - Removal and installation of the executive cylinder of coupling//Maxim's Nissan (from 1993 g) accessories-sale.ru

Nissan Maxima QX

since 1993 of release

Repair and car operation



Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Transmission
- Coupling and power shafts
   General information
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal, check of a condition and installation of components of assembly of coupling
   Removal, check of a condition and installation of the vyzhimny bearing and lever of switching off of coupling
   Adjustment of a pedal of coupling
   Check of serviceability of functioning and replacement of the sensor switch of disconnection of a chain of a starter
   Power shafts - the general information and condition check
   Removal and installation of power shafts
   Check of a condition and replacement of assembly of the basic bearing
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
9a1e70e9



Removal and installation of the executive cylinder of coupling

Components of assembly of the executive cylinder of coupling

1 — the Case
2 — a piston Spring
3 — a piston Cover
4 — the Piston

5 — a pusher Rod
6 — the Boot
7 — the pumping Gate (6 ÷ 10 Nanometer)

REMOVAL

 PERFORMANCE ORDER

1. Components of assembly of the executive cylinder of coupling are presented on an illustration.
2. Disconnect a negative wire from the battery.

 If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

3. In case of need for the purpose of ensuring access remove the storage battery (see. Head engine Electric equipment).
4. Weaken a hollow bolt of the shtutserny socket of connection to the executive cylinder of the hydraulic line. Turn out bolts of fastening of assembly of the cylinder.
5. Disconnect the hydraulic line. Prepare container and a stock of dry rags for collecting spilled liquid.
6. Remove assembly of the executive cylinder from RKPP case.

INSTALLATION

 PERFORMANCE ORDER

1. Connect to the cylinder the hydraulic line (do not forget to replace sealing washers of the shtutserny socket). By hand tighten a hollow bolt of the socket.
2. Establish assembly on the regular place on a dome of coupling and tighten with demanded effort fixing bolts. Track correctness of landing of a pusher in a pocket of the lever of switching off of coupling. Tighten fixture with demanded effort.
3. With demanded effort tighten a hollow bolt of the shtutserny socket of the hydraulic line.
4. Fill in in the cylinder necessary amount of brake DOT 3 liquid.
5. Pump over hydraulic system (see. The section air Removal from a hydraulic path of a drive of switching off of coupling).
6. If removed, establish into place the storage battery. Connect a negative wire to the battery.