Nissan Maxima QX

since 1993 of release

Repair and car operation



Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Transmission
- Coupling and power shafts
   General information
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal, check of a condition and installation of components of assembly of coupling
   Removal, check of a condition and installation of the vyzhimny bearing and lever of switching off of coupling
   Adjustment of a pedal of coupling
   Check of serviceability of functioning and replacement of the sensor switch of disconnection of a chain of a starter
   Power shafts - the general information and condition check
   Removal and installation of power shafts
   Check of a condition and replacement of assembly of the basic bearing
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
9a1e70e9



Removal, check of a condition and installation of the vyzhimny bearing and lever of switching off of coupling

 Remember that developed in the course of wear of frictional overlays of a conducted disk of coupling the dust can contain unhealthy asbestos. Do not blow off a dust the compressed air and try not to inhale it. Do not apply to rubbing of components of coupling solvents on an oil basis, - use only special brake cleaners or pure methyl alcohol. The used rags before utilization put in tightly closed container.

REMOVAL

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

 If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Remove a transmission (see. Removal and RKPP installation).

3. Remove the lever of switching off of coupling from a spherical hairpin, then remove from the lever vyzhimny the bearing.

CHECK

 PERFORMANCE ORDER

Holding the bearing for an external holder, press two fingers internal and повращайте it. The bearing should rotate freely and silently, otherwise it is necessary to replace it. Wipe the bearing pure rags and examine on existence of signs of wear, cracks and other mechanical damages. Usually replacement of the vyzhimny bearing is made each time at service of components of coupling. At all do not wash out the bearing in solvent in order to avoid violation of tightness of its assembly. Check the lever of switching off of coupling on existence of cracks and signs of deformations.

INSTALLATION

 PERFORMANCE ORDER

1. With refractory greasing grease a surface of the holder of the bearing певала.

2. With the same greasing grease a nest under landing of a spherical finger from a reverse side of assembly of the lever of switching off, and also a nest under landing of a pusher of the executive cylinder.

3. Plant in assembly of the lever of switching off of coupling fixing spring of a spherical support and vyzhimny the bearing.

4. Plant vyzhimny the bearing on the holder of the forward bearing of primary shaft of a transmission, at the same time passing the end of the lever of switching off through an opening in a coupling casing. Densely plant a switching off fork on a sharovy finger of a spherical support.
5. Slightly grease with refractory greasing contacting to petals of a diafragmenny spring a surface of the vyzhimny bearing.
6. Further installation is made as it should be, the return to an order of dismantle of components.