Nissan Maxima QX

since 1993 of release

Repair and car operation


Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Transmission
- Coupling and power shafts
   General information
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal, check of a condition and installation of components of assembly of coupling
   Removal, check of a condition and installation of the vyzhimny bearing and lever of switching off of coupling
   Adjustment of a pedal of coupling
   Check of serviceability of functioning and replacement of the sensor switch of disconnection of a chain of a starter
   Power shafts - the general information and condition check
   Removal and installation of power shafts
   Check of a condition and replacement of assembly of the basic bearing
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

9a1e70e9 Смотрите http://www.prostitutkispb.su бардель в спб.
индивидуалки нижневартовска
Смотрите http://www.a.topgirls54.com проститутки Новосибирска.

Adjustment of a pedal of coupling

Measurement of height of a pedal of coupling (N)

1 — the Basic arm of a pedal
2 — the Stopper of adjustment of a full speed of a pedal
3 — the Overlay of a block of a pedal
4 — the floor Panel

5 — the Polymeric covering of a floor
6 — the Rug
7 — Insulating laying

Pedal height

 PERFORMANCE ORDER

1. At the released pedal of coupling measure distance of N from a surface of a rubber overlay of a block to a floor.
2. Compare result of measurement to requirements of Specifications, in case of need make the corresponding adjustment.

3. Weaken a lock-nut of an emphasis of a pedal / датчика-выключателя ASCD.

4. Emphasis rotation / датчика-выключателя achieve the demanded provision of a pedal.
5. Tighten a lock-nut and repeat check of installation of height of a pedal.

Free wheeling of a pedal

 PERFORMANCE ORDER

1. Slightly press a pedal of coupling and measure length of its course till resistance emergence. Compare result of measurement to requirements of Specifications. In case of need make the corresponding adjustment.

2. Weaken a lock-nut of a pusher of the main cylinder and, rotating a pusher rod in the relevant party (clockwise or against), achieve demanded result.
3. Strongly tighten a lock-nut and repeat check.