Nissan Maxima QX

since 1993 of release

Repair and car operation



Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Transmission
- Coupling and power shafts
   General information
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Air removal from a hydraulic path of a drive of switching off of coupling
   Removal, check of a condition and installation of components of assembly of coupling
   Removal, check of a condition and installation of the vyzhimny bearing and lever of switching off of coupling
   Adjustment of a pedal of coupling
   Check of serviceability of functioning and replacement of the sensor switch of disconnection of a chain of a starter
   Power shafts - the general information and condition check
   Removal and installation of power shafts
   Check of a condition and replacement of assembly of the basic bearing
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
9a1e70e9



Check of serviceability of functioning and replacement of the sensor switch of disconnection of a chain of a starter

 PERFORMANCE ORDER

1. The sensor switch of disconnection of a chain of a starter is located near the top end of a pedal of coupling.
2. Check correctness of installations of height of a pedal and size of a free wheeling of a pusher (see. Section Adjustment of a pedal of coupling).
3. Make sure that start of the engine is not possible at the released pedal of coupling.
4. Make sure of non-failure operation of start of the engine at the squeezed-out pedal of coupling.
5. If serviceability of functioning of the sensor switch is broken, it is necessary to check correctness of its electric conditions.
6. By means of an ohmmeter make sure available conductivity between plugs of the contact socket of assembly at the squeezed-out plunzher of the sensor switch.
7. At an otpuskaniye of a plunzher conductivity should disappear.
8. The faulty sensor switch is subject to replacement, - release a lock-nut on the sensor case, then turn out assembly and disconnect from it electroconducting. Installation is made upside-down.
9. Adjust a coupling pedal (see. Section Adjustment of a pedal of coupling)
10. Make sure that start of the engine becomes possible only when squeezing a pedal of coupling.