Nissan Maxima QX

since 1993 of release

Repair and car operation



Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Transmission
+ Coupling and power shafts
- Brake system
   General information
   System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
   Replacement of brake shoes of disk brake mechanisms
   Removal and installation of supports of disk brake mechanisms
   Condition check, removal and installation of a brake disk
   Replacement of boots of drum-type brake mechanisms of back wheels
   Removal and installation of wheel cylinders
   Removal and installation of the main brake cylinder
   Replacement of the dosing-out valve regulator
   Check of a condition and replacement of brake lines and hoses
   Pumping of brake system
   Check of serviceability of functioning/tightness, replacement and adjustment of the vacuum amplifier of brakes
   Adjustment of the parking brake
   Cable replacement (ов) drive of the parking brake
   Adjustment of a pedal of a foot brake
   Check of serviceability of functioning and replacement of the sensor switch of stoplights
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



Replacement of the dosing-out valve regulator

 PERFORMANCE ORDER

 On models 1993 and 1994 of вып. the dosing-out valve regulator is built in GTTs assembly.

1. On models since 1995 вып., not equipped the system of anti-blocking of brakes (ABS), provided two dosing-out valves regulators, both of them are screwed in GTTs assembly. On models with ABS separately established valve regulator is used.
2. Valves regulators are not subject to service and if wheels when braking start to be blocked ahead of time the car it is necessary to drive away for check on car repair shop, - the special manometer is required.
3. If the valve allows leaks or is otherwise damaged, release a special cap natural a cutting head a shtutserny nut, then отболтите the valve from a basic arm and turn out it from assembly of the main brake cylinder. After performance of replacement of the valve pump over brake system (see. Section Pumping of brake system).