Nissan Maxima QX

since 1993 of release

Repair and car operation

Removal and installation of levers of a back suspension bracket (model 1993 and 1994 of вып.)

Weaken wheel nuts. To Poddomkratta a car back also establish it on props. Remove back wheels.

Cross-section levers

PERFORMANCE ORDER

1. Give nuts of axial bolts of fastening of the internal ends of cross-section levers.

2. Give nuts/bolts of fastening of the external ends of cross-section levers to assembly of a rotary fist.
3. Remove levers.
4. Installation is made upside-down. Track, that all fixture was tightened with demanded effort.

The final tightening of fixture is made after components will be deduced on normal working height - prop up a suspension bracket a jack. The head of a jack should be got under an arm of the longitudinal lever!

5. Drive away the car on car repair shop for check and adjustment of geometry of a suspension bracket.

Longitudinal levers

PERFORMANCE ORDER

1. Give a nut of an axial bolt of fastening of the forward end of the longitudinal lever. Take a bolt.

2. Release boltovy pair of fastening of the back end of the lever on a basic arm.

3. Remove assembly of the longitudinal lever.
4. Installation is made upside-down. Before a final tightening of fixture with demanded effort поддомкратьте stupichny assembly for removal of elements of a suspension bracket on normal working height.

The jack should be got under an arm of fastening of the longitudinal lever!

All levers

PERFORMANCE ORDER

Establish to the place of a wheel, lower the car on the earth and tighten wheel nuts with demanded effort (see. Head of Control and routine maintenance).