Nissan Maxima QX

since 1993 of release

Repair and car operation



Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   General information
   Removal, check of a condition and installation of rack-mount assemblies of a forward suspension bracket
   Shock-absorber replacement / screw spring of rack-mount assembly
   Removal and installation of assembly of a rotary fist with a nave
   Removal and installation of assembly of a forward nave with the wheel bearing
   Removal and installation of the forward stabilizer of cross-section stability
   Removal and installation of a control lever of a forward suspension bracket
   Replacement of spherical support
   Removal, check of a condition and installation of racks of a back suspension bracket
   Removal and installation of assembly of a back nave with the wheel bearing
   Removal and installation of a bar of the back stabilizer of cross-section stability (model 1993 and 1994 of вып.)
   Removal and installation of levers of a back suspension bracket (model 1993 and 1994 of вып.)
   Removal and installation of components of a back suspension bracket of models from 1995 вып.
   Removal and installation of a steering wheel
   Removal and installation of tips of steering drafts
   Replacement of protective covers of assembly of the steering mechanism
   Removal, dismantle and installation of reechny transfer
   Removal and installation of the steering pump
   Air removal from a hydraulic path of system of strengthening of a wheel
   Replacement of wheel hairpins
   Wheels and tires - the general information
   Corners of installation of wheels
+ Body
+ Onboard electric equipment
9a1e70e9



Removal and installation of tips of steering drafts

REMOVAL

 PERFORMANCE ORDER

1. Weaken nuts of fastening of the corresponding wheel. Cock the parking brake, prop up protivootkatny boots back wheels, then поддомкратьте a front of the car and establish it on props. Remove a wheel.

2. Holding a draft tip from a provorachivaniye the second key, release a lock-nut. Unscrew a nut so that there was a possibility to put a label of provision of a tip on open rounds of a carving of a bar.

3. Take шплинт and weaken a nut of a spherical finger of a tip. It is not necessary while finally to remove a nut.

4. With the help 2-захватного a stripper liberate a sharovy finger of a tip from the lever of assembly of a rotary fist. Remove a nut and separate draft from a fist.

5. Unscrew a tip and remove it from a draft bar.

INSTALLATION

 PERFORMANCE ORDER

1. Screw on draft a new tip (to the landing label put in the course of dismantle on rounds of a carving of a bar). Plant a sharovy finger of a tip in the lever of a rotary fist. Strongly tighten a lock-nut.
2. Screw a koronchaty nut of a spherical finger and tighten it with demanded effort. Fix a nut new the shplinty.
3. Establish a wheel, lower the car on the earth and tighten wheel nuts with demanded effort (see. Specifications to Head of Control and routine maintenance).
4. Drive away the car in a specialized workshop for check and adjustment of corners of installation of forward wheels.