Nissan Maxima QX

since 1993 of release

Repair and car operation



Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   General information
   Removal, check of a condition and installation of rack-mount assemblies of a forward suspension bracket
   Shock-absorber replacement / screw spring of rack-mount assembly
   Removal and installation of assembly of a rotary fist with a nave
   Removal and installation of assembly of a forward nave with the wheel bearing
   Removal and installation of the forward stabilizer of cross-section stability
   Removal and installation of a control lever of a forward suspension bracket
   Replacement of spherical support
   Removal, check of a condition and installation of racks of a back suspension bracket
   Removal and installation of assembly of a back nave with the wheel bearing
   Removal and installation of a bar of the back stabilizer of cross-section stability (model 1993 and 1994 of вып.)
   Removal and installation of levers of a back suspension bracket (model 1993 and 1994 of вып.)
   Removal and installation of components of a back suspension bracket of models from 1995 вып.
   Removal and installation of a steering wheel
   Removal and installation of tips of steering drafts
   Replacement of protective covers of assembly of the steering mechanism
   Removal, dismantle and installation of reechny transfer
   Removal and installation of the steering pump
   Air removal from a hydraulic path of system of strengthening of a wheel
   Replacement of wheel hairpins
   Wheels and tires - the general information
   Corners of installation of wheels
+ Body
+ Onboard electric equipment





9a1e70e9



Replacement of protective covers of assembly of the steering mechanism

 PERFORMANCE ORDER

1. Weaken nuts of fastening of the corresponding wheel. To Poddomkratta a car front also establish it on props. Remove a wheel.
2. Remove from a bar of steering draft a tip and its lock-nut (see. Section Removal and installation of tips of steering drafts).
3. Having compressed flat-nose pliers lock uvulas remove collars of fastening of the external ends of protective covers of a case of reechny transfer. Wire bandages of fastening of the external ends of covers should be had a bite бокорезами.

4. Before installation of a new cover wind the cut end of steering draft with an adhesive tape casually not to damage small sponges of a cover when landing it on draft.
5. Put on a new cover draft and pull it on a crater of the steering mechanism, having tracked correctness of landing of sealing sponges in a reception flute. Fix a cover, having imposed a wire bandage two шлагами.
6. Remove an adhesive tape and screw on a place a tip of steering draft (see. Section Removal and installation of tips of steering drafts).
7. Establish into place a wheel. Lower the car on the earth and tighten wheel nuts with demanded effort (see. Specifications to Head of Control and routine maintenance).