The device, service, Nissan Maxima QX repair - air Removal from a hydraulic path of system of strengthening of a wheel//Maxim's Nissan (from 1993 g) accessories-sale.ru

Nissan Maxima QX

since 1993 of release

Repair and car operation



Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   General information
   Removal, check of a condition and installation of rack-mount assemblies of a forward suspension bracket
   Shock-absorber replacement / screw spring of rack-mount assembly
   Removal and installation of assembly of a rotary fist with a nave
   Removal and installation of assembly of a forward nave with the wheel bearing
   Removal and installation of the forward stabilizer of cross-section stability
   Removal and installation of a control lever of a forward suspension bracket
   Replacement of spherical support
   Removal, check of a condition and installation of racks of a back suspension bracket
   Removal and installation of assembly of a back nave with the wheel bearing
   Removal and installation of a bar of the back stabilizer of cross-section stability (model 1993 and 1994 of вып.)
   Removal and installation of levers of a back suspension bracket (model 1993 and 1994 of вып.)
   Removal and installation of components of a back suspension bracket of models from 1995 вып.
   Removal and installation of a steering wheel
   Removal and installation of tips of steering drafts
   Replacement of protective covers of assembly of the steering mechanism
   Removal, dismantle and installation of reechny transfer
   Removal and installation of the steering pump
   Air removal from a hydraulic path of system of strengthening of a wheel
   Replacement of wheel hairpins
   Wheels and tires - the general information
   Corners of installation of wheels
+ Body
+ Onboard electric equipment
9a1e70e9



Air removal from a hydraulic path of system of strengthening of a wheel

 PERFORMANCE ORDER

1. After performance of any procedures connected with a detachment of lines of the hydraulic booster, it is necessary to remove air from a hydraulic path of PAS. Otherwise efficiency of functioning of the steering amplifier considerably will decrease.
2. Develop forward wheels of the car in rectilinear situation and check liquid level in the PAS system tank (see. Head of Control and routine maintenance). In case of need make the corresponding adjustment (level of liquid should reach the bottom point [COLD] in a tank wall).
3. To Poddomkratta a car front also establish it on props.
4. Start the engine and leave its working at turns of fast idling. Once again check liquid level in the PAS tank. In case of need again make adjustment.
5. With rotation of a steering wheel here and there (without blows in the course ends) remove from system air (watch that liquid level in the tank during pumping did not fall below an admissible limit).
6. Having finished pumping, return wheels to rectilinear situation and let's to the engine work within several more minutes, then muffle it.
7. Lower the car on the earth.
8. Make trial runs of the car, checking serviceability and noiselessness of functioning of steering system.
9. Once again check level of hydraulic liquid at the heated-up engine to normal working temperature (this time it should reach a mark of NOTES in a tank wall). In case of need make necessary adjustment (see. Head of Control and routine maintenance).