The device, service, Nissan Maxima QX repair - Removal and installation of the forward stabilizer of cross-section stability//Maxim's Nissan (from 1993 g) accessories-sale.ru

Nissan Maxima QX

since 1993 of release

Repair and car operation



Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   General information
   Removal, check of a condition and installation of rack-mount assemblies of a forward suspension bracket
   Shock-absorber replacement / screw spring of rack-mount assembly
   Removal and installation of assembly of a rotary fist with a nave
   Removal and installation of assembly of a forward nave with the wheel bearing
   Removal and installation of the forward stabilizer of cross-section stability
   Removal and installation of a control lever of a forward suspension bracket
   Replacement of spherical support
   Removal, check of a condition and installation of racks of a back suspension bracket
   Removal and installation of assembly of a back nave with the wheel bearing
   Removal and installation of a bar of the back stabilizer of cross-section stability (model 1993 and 1994 of вып.)
   Removal and installation of levers of a back suspension bracket (model 1993 and 1994 of вып.)
   Removal and installation of components of a back suspension bracket of models from 1995 вып.
   Removal and installation of a steering wheel
   Removal and installation of tips of steering drafts
   Replacement of protective covers of assembly of the steering mechanism
   Removal, dismantle and installation of reechny transfer
   Removal and installation of the steering pump
   Air removal from a hydraulic path of system of strengthening of a wheel
   Replacement of wheel hairpins
   Wheels and tires - the general information
   Corners of installation of wheels
+ Body
+ Onboard electric equipment
9a1e70e9



Removal and installation of the forward stabilizer of cross-section stability

 PERFORMANCE ORDER

1. Cock the parking brake and prop up protivootkatny boots back wheels. Weaken nuts of fastening of forward wheels. To Poddomkratta a car front also establish it on props. Remove wheels.
2. Disconnect racks of the stabilizer of cross-section stability from both control levers of a suspension bracket.

3. Remove collars of basic plugs of a bar of the stabilizer of cross-section stability.

4. Remove assembly of a bar of the stabilizer.
5. After extraction of a bar remove from it homutny assemblies and carefully check a condition of rubber plugs. In case of identification of signs of destruction of a material replace defective components.
6. Installation is made upside-down. Track, that plugs appeared are developed by cuts forward, and all fixture was tightened with demanded effort.