The device, service, Nissan Maxima QX repair - Replacement of spherical support//Maxim's Nissan (from 1993 g) accessories-sale.ru

Nissan Maxima QX

since 1993 of release

Repair and car operation


Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   General information
   Removal, check of a condition and installation of rack-mount assemblies of a forward suspension bracket
   Shock-absorber replacement / screw spring of rack-mount assembly
   Removal and installation of assembly of a rotary fist with a nave
   Removal and installation of assembly of a forward nave with the wheel bearing
   Removal and installation of the forward stabilizer of cross-section stability
   Removal and installation of a control lever of a forward suspension bracket
   Replacement of spherical support
   Removal, check of a condition and installation of racks of a back suspension bracket
   Removal and installation of assembly of a back nave with the wheel bearing
   Removal and installation of a bar of the back stabilizer of cross-section stability (model 1993 and 1994 of вып.)
   Removal and installation of levers of a back suspension bracket (model 1993 and 1994 of вып.)
   Removal and installation of components of a back suspension bracket of models from 1995 вып.
   Removal and installation of a steering wheel
   Removal and installation of tips of steering drafts
   Replacement of protective covers of assembly of the steering mechanism
   Removal, dismantle and installation of reechny transfer
   Removal and installation of the steering pump
   Air removal from a hydraulic path of system of strengthening of a wheel
   Replacement of wheel hairpins
   Wheels and tires - the general information
   Corners of installation of wheels
+ Body
+ Onboard electric equipment
 9a1e70e9


Replacement of spherical support

Models 1993 and 1994 of вып.

 PERFORMANCE ORDER

1. Weaken Nuts of fastening of the corresponding wheel. To Poddomkratta the car also establish it on props. Remove a wheel.
2. Liberate a spherical support from a rotary fist (see. Section Removal and installation of a control lever of a forward suspension bracket).
3. Give three nuts of fastening of a support to a fist. Disconnect a support from a control lever.
4. Installation is made upside-down. Track, that all fixture was tightened with demanded effort. Do not forget to replace шплинт.

 If for combination of grooves of a crown with an opening under landing шплинта the provision of a nut is necessary for correcting, tighten it on a demanded corner, - at all do not weaken.

5. Establish into place a wheel, lower the car on the earth and tighten wheel nuts with demanded effort (see. Head of Control and routine maintenance).

Models since 1995 вып.

 PERFORMANCE ORDER

On models since 1995 вып. the spherical support is built in assembly of a control lever of a suspension bracket and in case of wear or damage changes complete with the last (see. Section Removal and installation of a control lever of a forward suspension bracket).