The device, service, Nissan Maxima QX repair - Check of serviceability of functioning and replacement of podrulevy switches//Maxim's Nissan (from 1993 g) accessories-sale.ru

Nissan Maxima QX

since 1993 of release

Repair and car operation



Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   General information and precautionary measures
   Search of causes of failures of electric equipment
   Safety locks and fusible inserts - the general information
   Chain breakers - the general information
   The relay - the general information and check of serviceability of functioning
   Check of serviceability of functioning and replacement of the breaker of indexes of turns / alarm system
   Check of serviceability of functioning and replacement of podrulevy switches
   Check of serviceability of functioning and replacement of the switch of ignition and lock of blocking of a steering column
   Check of serviceability of functioning and replacement of switches of the dashboard
   Check of serviceability of functioning of measuring instruments of temperature of the engine and fuel consumption
   Removal and installation of a combination of devices
   Removal and installation of a radio receiver and loudspeakers
   Removal and installation of the aerial of a radio receiver
   Replacement of lamps of head headlights
   Adjustment of the direction of optical axes of head headlights
   Removal and installation of block headlights
   Replacement of lamps
   Check of serviceability of functioning, removal and installation of the electromotor of a drive of screen wipers
   Check of serviceability of functioning and replacement of horns of a horn
   Running fires of light time of day (DRL)
   Check of serviceability of functioning and regenerative repair of a heater of back glass
   Control system of speed (темпостат) - general information and check of serviceability of functioning
   The electric drive of window regulators - general information and check of serviceability of functioning
   The uniform lock - general information and check of serviceability of functioning
   The electric drive of external rear-view mirrors - general information and check of serviceability of functioning
   The electric drive of the top hatch - general information and check of serviceability of functioning
   The electric drive of forward seats - general information and check of serviceability of functioning
   Transfer of management by functioning of onboard consumers of the electric power on switched lines
   Safety cushions - the general information
   + Schemes of electric connections
9a1e70e9



Check of serviceability of functioning and replacement of podrulevy switches

 Models of cars considered in the real Management are equipped with system of additional safety (SRS). Before starting performance of any works near the block of a safety cushion, a steering column or the dashboard, disconnect SRS in order to avoid receiving traumas at its casual operation. Electroconducting of a chain of SRS is easy for distinguishing on yellow color of isolation.

The combined switch

CHECK

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery and wait not less than three minutes before starting slip dismantle.

 If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Remove assembly of the combined switch (see below subsection Replacement).
3. By means of an ohmmeter or the lamp sampler equipped with the individual power supply check correctness of distribution of conductivity between switch plugs in its various provisions.

 

Position of the switch
Conductivity existence between plugs
Head headlights are switched off, situation C
5 and 6, 8 and 9
Parking fires, situation A or B
11 and 12
Parking fires, situation C
5 and 6, 8 and 9, 11 and 12
Head headlights, situation A or C
5 and 6, 8 and 9, 11 and 12
Head headlights, situation B
5 and 7, 8 and 10, 11 and 12
Head headlights, situation C
5 and 6, 8 and 9, 11 and 12
Indexes of the right turn
1 and 2
Indexes of the left turn
1 and 3
Indexes of the right turn / lateral repeater
61 and 62
Indexes of the left turn / lateral repeater
61 and 63

 

Position of the switch
Conductivity existence between plugs
Vykl
13 and 14
Interval mode
13 and 14, 15 and 17
Slow mode
17 and 17
Fast mode
16 and 17
Glass washing
17 and 18

4. In case of identification of violations replace the switch.

REPLACEMENT

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery and wait not less than three minutes before starting slip dismantle.

 If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Remove a steering wheel (see. Head Suspension bracket and steering).
3. Remove a driver's knee emphasis and covers of a casing of a steering column (see. Head Body).

4. Turn out four fixing screws and remove from the combined switch spring contact of a driver's safety cushion (see. Head Suspension bracket and steering). Turn out screws of fastening of assembly of the combined switch.

5. Remove assembly of the combined switch from a steering column and disunite contact sockets of electroconducting.

6. Turn out screws of fastening of the individual switch subject to replacement and remove the last from the case of the combined switch.

7. Connect the new switch to plugs of the contact socket, - track reliability of fixing of assembly in a block.
8. Further assembly is made as it should be the return to an order of dismantle of components. The description of procedure of installation of spring contact of a safety cushion is provided in Head the Suspension bracket and a steering.

Switches of a control system in the speed

CHECK

 PERFORMANCE ORDER

1. The panel of switches of management темпостата (except the switch Vkl/Vykl) is established by functioning on the right on a steering wheel of the car.

2. Remove the switch (see below). By means of an ohmmeter or the lamp sampler equipped with the individual power supply check correctness of distribution of conductivity between switch plugs in its various provisions.

Position of the switch
Conductivity existence between plugs
Resume/Accel
(Return/acceleration)
1 and 3
Set/Coast
(Installation / Nakat)
1 and 2
Cancel
(Dumping)
1 and 3 *, 1 and 2* (with diodes)
* diodes Are used, check both directions

3. The faulty switch is subject to replacement.

REPLACEMENT

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery and wait not less than three minutes before starting slip dismantle.

 If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Having hooked the screw-driver passed in a special groove, uncover panels.

3. Turn out fixing screws, remove assembly of the switch and disconnect from it electroconducting.

4. Installation is made upside-down.