1. Replacement of ATF should be made on a regular basis, according to the schedule of routine maintenance of the car. 2. Prepare fresh transmission liquid of the corresponding grade (see. Specifications at the beginning of Head). 3. Number other necessary performance for the forthcoming procedure of tools and materials treat: props for car fixing in the lifted situation, a six-sided prutkovy key of the suitable size with a long collar, drain capacity in volume not less than 7.5 l and a stock of rags and/or old newspapers. 4. Liquid should merge, previously being heated-up to normal working temperature during a short trip. Hot ATF possesses higher fluidity and better washes away шлам and other deposits.
|
The worker температураATF can reach 180°С! Be careful, work in rubber gloves. |
5. Having made a short trip and ATF warming up to normal working temperature, park the car on an equal horizontal platform with a firm covering, поддомкратьте it and establish on props, having provided a free access to a drain stopper of a case of transmission. 6. Get under a transmission case drain capacity and all necessary stock. Try not to touch to located under with the car bottom to the warmed-up components of the power unit and system of production of the fulfilled gases.
|
7. Having placed properly reception container, turn out a drain stopper. Do not forget that during the first moment of ATF will start to follow with a relative pressure which, in process of decrease of level of liquid, will gradually decrease, - be ready to correct in time as appropriate the provision of drain capacity. When the liquid effluence completely will stop, wipe a drain stopper, screw it on the regular place and strongly tighten. |
|
8. Turn out forward bolts of fastening of the pallet of a case of transmission, then weaken back and, having hooked the pallet a screw-driver, let out from AT case ATF remains. Upon termination of a liquid effluence finally turn out the remained bolts and lower the pallet on the earth. Turn out fixing bolts and remove the filter, having omitted assembly down. Be careful, - in the filter inevitably there is a liquid quantity. |
9. Establish to the place of the removed filter the new.
|
10. Carefully smooth out interfaced surfaces of a case of transmission and a landing flange of its pallet, having completely removed from them traces of a material of old laying and hermetic, wipe internal surfaces of the pallet. Remembering adjusting provisions of components, remove from the pallet protective magnets, wash out them in solvent and dry the compressed air (do not forget to put on goggles). Do not forget to establish magnets on the former places in the pallet, previously having replaced laying. |
11. Having replaced laying, establish the pallet on the regular place and fix it bolts, having screwed them in the former provisions and having tightened at first by hand. In stages, on 1/4 turns for an approach, tighten fixture with demanded effort, - be not overzealous! 12. Without starting the engine, take from a transmission case measuring щуп and through an opening in a directing tube fill in necessary amount of fresh liquid of a demanded grade (see. Specifications). For the purpose of minimization of losses of ATF use a funnel. Fill in liquid in the small portions, periodically checking its level on щупу (see. Section Check of level of ATF of automatic transmission). Do pauses, allowing the filled-in liquid to flow down on a pallet bottom.
|
At the beginning of the present chapter the volume of ATF is specified in Specifications taking into account the rotation converter. During described above procedure all liquid present at transmission therefore do not fill in in a case of more ATF merges not, than from it was merged. Constantly watch level of added liquid (see. Section Check of a condition of components of system of cooling). |
13. Start the engine, then slowly carry out the selector lever through all provisions from "R" to “L”, then return it in initial ("R") then cock the parking brake. 14. At the engine working at single turns check ATF level in transmission, in case of need make the corresponding adjustment, having finished liquid level to a mark of COOL in an edge measuring щупа. |