Nissan Maxima QX

since 1993 of release

Repair and car operation



Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
- Engine
   - SOHC engines
      General information
      Preparatory actions and the list of repair procedures which can be executed without engine extraction from the car
      Reduction of the piston of the first cylinder in the provision of the top dead point (VMT)
      Removal and installation of covers of heads of cylinders
      Removal, check of a condition and installation of assembly of yokes
      Replacement of maslootrazhatelny caps and klapanny springs with plates
      Removal and installation of a gas-distributing belt and cogwheels of a drive of GRM
      Removal and installation of camshafts and pushers of valves
      Removal and installation of the inlet pipeline
      Removal and installation of final collectors
      Removal and installation of heads of cylinders
      Removal and installation of a pulley of a cranked shaft
      Replacement of a forward epiploon of a cranked shaft
      Removal and installation of the pallet of a case of the engine
      Removal, check of a condition and installation of the oil pump
      Removal and flywheel installation / driving disk
      Replacement of a back epiploon of a cranked shaft
      Check of a condition and replacement of support of a suspension bracket of the power unit
   + DOHC Engines
   + General major maintenance of the engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





9a1e70e9



Replacement of a back epiploon of a cranked shaft

 PERFORMANCE ORDER

1. Hang out the unit from above on the winch or a beam and remove a transmission (see. Head Transmission). Remove a flywheel / a driving disk (see. Section Removal and flywheel installation / driving disk).

2. Having accurately hooked a screw-driver, take an old epiploon from a landing nest in the holder.

3. Grease a pin of a cranked shaft and a sponge of a new epiploon with universal greasing. Landing of an epiploon is carried out by means of an opravka as which the face head of the corresponding size, or a piece of a pipe of suitable diameter can be used. As a last resort, простозастучите an epiploon in a nest a stupid drift. Track perpendicularity of landing of an epiploon in a nest.

The epiploon has rather rigid sponges which are easy for damaging, observe extreme care! Landing is carried out not more deeply than aflush with a back of the holder.

4. Further installation is made as it should be, the return to an order of dismantle of components.
5. Start the engine and check its existence of signs of leakages of oil.