Nissan Maxima QX

since 1993 of release

Repair and car operation

Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
- Engine
   + SOHC Engines
   - DOHC engines
      General information
      Preparatory actions and the list of repair procedures which can be executed without engine extraction from the car
      Reduction of the piston of the first cylinder in the provision of the top dead point (VMT)
      Removal and installation of covers of heads of cylinders
      Check and adjustment of gaps of valves
      Replacement of maslootrazhatelny caps and klapanny springs with plates
      Removal, check of a condition and installation of a chain and asterisks of a drive of GRM
      Removal and installation of camshafts and pushers of valves
      Removal and installation of the inlet pipeline
      Removal and installation of final collectors
      Removal and installation of heads of cylinders
      Removal and installation of a pulley of a cranked shaft
      Replacement of a forward epiploon of a cranked shaft
      Removal and installation of the pallet of a case of the engine
      Removal, check of a condition and installation of the oil pump
      Removal and flywheel installation / driving disk
      Replacement of a back epiploon of a cranked shaft
      Check of a condition and replacement of support of a suspension bracket of the power unit
   + General major maintenance of the engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

9a1e70e9 Best credit! Low interest rates, if you need quick Same Day Loan get it here.

Removal and installation of a pulley of a cranked shaft


1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

2. Prop up protivootkatny boots back wheels of the car, cock the parking brake.
3. Weaken nuts of fastening of the right forward wheel. To Poddomkratta a car front also establish it on props, remove the right forward wheel.
4. Remove protection of a case and a loker of protection of an arch of the right forward wheel.
5. Remove driving belts (see. Head of Control and routine maintenance).
6. Remove from a forward cover of a drive of GRM the sensor of provision of a cranked shaft (see. Head of the Control system of the engine).

7. Having blocked шив a cranked shaft from a provorachivaniye by means of a chain or tape key, give the central bolt of its fastening.

8. Having hooked a pulley from two parties screw-drivers or big mount, carefully remove it from a shaft pin. In case of need use 3ахватным a stripper.

Get stripper captures only under a stupichny part of a pulley!

9. Installation is made upside-down. Before landing of a pulley to a pin of a shaft track correctness of combination of a shponka with a reciprocal groove. A fixing bolt tighten with demanded effort.