Nissan Maxima QX

since 1993 of release

Repair and car operation



Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
- Systems of cooling, heating
   General information
   Antifreeze - general information
   Check of serviceability of functioning and thermostat replacement
   Check of a condition of fans of system of cooling and chains of their inclusion, replacement of components
   Removal and installation of a radiator and expanded tank of system of cooling
   Check of a condition and replacement of the water pump
   Check of serviceability of functioning and replacement of the block of the sensor of a measuring instrument of temperature of cooling liquid
   Check of serviceability of functioning of the driving electromotor of the fan of a heater and condition of components of its electric chain, …
   Removal and installation of the electromotor of a drive of the fan of a heater
   Removal and installation of assembly of the control panel by functioning of a heater and air conditioner, adjustment of a driving cable
   Removal and installation of the heat exchanger of a heater
   Check of serviceability of functioning and service of systems of heating and air conditioning
   Removal and receiver dehumidifier installation To/in
   Removal, service and To/in compressor installation
   Removal and To/in condenser installation
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
+ Transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





9a1e70e9



Removal and installation of assembly of the control panel by functioning of a heater and air conditioner, adjustment of a driving cable

Cars considered in the real Management are equipped with system of additional safety of SRS which is better known as a safety cushion. Before performing any works near assembly of a pillow or a steering column, without fail disconnect system in order to avoid receiving traumas as a result of its casual operation, - disconnect from the battery at first negative, then for a positive wire and wait not less than two minutes before starting service of the components located near sensors of directed overloads (see. Head Onboard electric equipment). Isolation and contact sockets of electroconducting of a chain of SRS are painted in bright yellow color. It is not necessary to connect any diagnostic devices to this chain!


 PERFORMANCE ORDER

1. Remove the central facing of the dashboard (see. Head Body).

2. Turn out four screws of fastening of assembly of management to the dashboard.

3. Take assembly from the landing nest in the panel and disconnect electroconducting.
4. The description of procedures of check of the switch of a choice of high-speed modes of the fan of a heater see in the Section Check of serviceability of functioning of the driving electromotor of the fan of a heater and a condition of components of its electric chain. For extraction of switches from the panel it is necessary to remove from handle levers, to turn out four screws of fastening of a casing of the printed-circuit board, then to wring out plastic lock uvulas from the back party of the corresponding switch and to liberate it from the panel.
5. Installation is made upside-down.