Nissan Maxima QX + Nissan Maxima brand Cars + Maintenance instruction + Settings and routine maintenance + Engine + Systems of cooling, heating - Power supply system and release General information Sbrasyvaniye of pressure in a power supply system Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel Check of a condition and replacement of fuel lines and their shtutserny connections Removal and installation of the fuel pump Check of a condition and replacement of the sensor of fuel consumption Removal and installation of a fuel tank Cleaning and repair of a fuel tank - general information Removal and installation of assembly of an air purifier Removal, installation and adjustment of a cable of an accelerator System of electronic injection of fuel (EFI) - the general information Check of serviceability of functioning of system of injection Check of a condition and replacement of the case of a throttle Removal and installation of a regulator of pressure of fuel Removal and installation of the fuel highway and injection injectors Check and adjustment of turns of idling Release system - the general information + engine Electric equipment + Control systems of the engine + Transmission + Coupling and power shafts + Brake system + Suspension bracket and steering + Body + Onboard electric equipment
|
Removal, installation and adjustment of a cable of an accelerator
|
Adjustment of hummocks of gas and drive темпостата is made in a similar manner. |
REMOVAL
|
|
1. Disconnect cables of gas and (at the corresponding complete set of the car) темпостата from the lever of a drive of a butterfly valve. |
|
2. Weaken lock and adjusting nuts and liberate an accelerator cable from the arm. |
|
3. Under the dashboard in a driver's foot well disconnect an accelerator cable from the lever of a pedal of gas, turn out bolts of fastening of hummock assembly to a partition of an impellent compartment. |
4. Release the remained intermediate clamps of a torso. 5. Involve a cable through a partition in an impellent compartment and remove it from the car. |
|
INSTALLATION
|
1. Installation is made upside-down. Track correctness of laying of a cable and reliability of its fastening in all provided clamps. 2. In case of need miss the mark with hermetic knot of a transmission of a cable through a partition in order to avoid moisture hit in car salon. |
|
ADJUSTMENT
|
1. Adjustment of a cable of an accelerator is made as follows:
a) Having pulled for a cable, choose all its weak point;; b) Give an adjusting nut before emergence of a free wheeling of the lever of a drive of a butterfly valve; c) Give an adjusting nut of a cable on 1.5 ÷ 2 turn; d) Tighten a lock-nut; e) Make sure of completeness of opening of a butterfly valve when squeezing a pedal of gas to a floor and its return to the starting (closed) position at a pedal otpuskaniye. Make sure of lack of signs of jamming; 2. Order of performance of adjustment of a cable темпостата:
a) Make sure correctness of adjustment of a cable of gas; b) Release an adjusting nut of a cable темпостата before emergence of a free wheeling of the lever of a zaslonka; c) Give an adjusting nut of a cable on a turn floor – a turn; d) Tighten a lock-nut and check serviceability of functioning темпостата. |
|
|
|