Nissan Maxima QX

since 1993 of release

Repair and car operation



Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
- Power supply system and release
   General information
   Sbrasyvaniye of pressure in a power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a condition and replacement of fuel lines and their shtutserny connections
   Removal and installation of the fuel pump
   Check of a condition and replacement of the sensor of fuel consumption
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - general information
   Removal and installation of assembly of an air purifier
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of injection
   Check of a condition and replacement of the case of a throttle
   Removal and installation of a regulator of pressure of fuel
   Removal and installation of the fuel highway and injection injectors
   Check and adjustment of turns of idling
   Release system - the general information
+ engine Electric equipment
+ Control systems of the engine
+ Transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
9a1e70e9



Removal and installation of a regulator of pressure of fuel

See preventions at the beginning of pressure Sbrasyvaniye's Section in a power supply system.


 PERFORMANCE ORDER

1. Dump pressure in a power supply system (see. Undressed Sbrasyvaniye pressure in a power supply system). Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for equipment input in action!

2. Disconnect from the throttle and air purifier case assembly of an inlet air line with the resonator.

3. Carefully wipe a regulator of pressure of fuel and surfaces surrounding it. Disconnect from a regulator a vacuum hose and the line of return of fuel /

4. Turn out two fixing screws and remove regulator assembly from the fuel highway.

5. Grease a new sealing ring of a regulator with pure impellent oil.
6. Installation is made upside-down. Track reliability of a tightening of fixture.