Nissan Maxima QX

since 1993 of release

Repair and car operation



Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
- Power supply system and release
   General information
   Sbrasyvaniye of pressure in a power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a condition and replacement of fuel lines and their shtutserny connections
   Removal and installation of the fuel pump
   Check of a condition and replacement of the sensor of fuel consumption
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - general information
   Removal and installation of assembly of an air purifier
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of injection
   Check of a condition and replacement of the case of a throttle
   Removal and installation of a regulator of pressure of fuel
   Removal and installation of the fuel highway and injection injectors
   Check and adjustment of turns of idling
   Release system - the general information
+ engine Electric equipment
+ Control systems of the engine
+ Transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
9a1e70e9



Check of a condition and replacement of the sensor of fuel consumption

See preventions at the beginning of pressure Sbrasyvaniye's Section in a power supply system.

CHECK

 PERFORMANCE ORDER

1. Take from a tank gasoline pump assembly with the fuel consumption sensor (see. Section Removal and installation of the fuel pump).

2. Connect to the corresponding two plugs of the socket of the sensor an ohmmeter.

3. Lower an assembly float in extreme bottom situation (an empty tank) and consider the ohmmeter indication. Compare the received result to requirements of Specifications.
4. Transfer a float to extreme top situation (a full tank) and repeat measurement. Again compare result to nominal rate.
5. If results of measurements fall outside the limits admissible ranges, or uniformity of change of indications is broken at float shift, it is necessary to replace assembly of the sensor.
6. On models 1993 and 1994 of вып. remove from a bearing arm the fuel pump and transfer it on new assembly (see. Section Removal and installation of the fuel pump). On models since 1995 вып. transfer on new assembly the sensor of temperature of fuel.
7. Establish assembly on the regular place in a fuel tank (do not forget to replace a sealing ring).
8. Further installation is made as it should be the return to an order of dismantle of components.