Nissan Maxima QX

since 1993 of release

Repair and car operation



Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
- Power supply system and release
   General information
   Sbrasyvaniye of pressure in a power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a condition and replacement of fuel lines and their shtutserny connections
   Removal and installation of the fuel pump
   Check of a condition and replacement of the sensor of fuel consumption
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - general information
   Removal and installation of assembly of an air purifier
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of injection
   Check of a condition and replacement of the case of a throttle
   Removal and installation of a regulator of pressure of fuel
   Removal and installation of the fuel highway and injection injectors
   Check and adjustment of turns of idling
   Release system - the general information
+ engine Electric equipment
+ Control systems of the engine
+ Transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
9a1e70e9



Removal and installation of a fuel tank

See preventions at the beginning of pressure Sbrasyvaniye's Section in a power supply system.


 PERFORMANCE ORDER

1. Dump pressure in a power supply system (see. Undressed Sbrasyvaniye pressure in a power supply system). For the purpose of dumping of superfluous pressure in a tank uncover a jellied mouth.
2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

3. If in a tank there is a fuel, pump out it by means of a special set (ask in shops of automobile accessories).

At all do not suck away fuel a mouth!

4. Remove a back seat and a cover of access to assembly (ам) the fuel pump and the fuel consumption sensor. Disconnect electroconducting plaits (see. Section Check of a condition and replacement of the sensor of fuel consumption).
5. To Poddomkratta the car also establish it on props.

6. Disconnect from unions on a tank of the line of giving and fuel return.

7. Weaken fixing collars and disconnect from a tank hoses of a jellied mouth, ventilation and system of catching of fuel evaporations (EVAP).

8. Prop up a tank a telezhechny jack, for distribution of loading having laid between a head of the last and a tank bottom wooden whetstone.

9. Turn out two of four bolts of fastening of assembly brackets of a tank - brackets should fall, having hung on the remained two bolts.

10. Slowly lower a tank below level of laying of sections of system of production of the fulfilled gases and take it from under the car.
11. The description of procedures of cleaning and regenerative repair of a tank is provided in the Section Cleaning and repair of a fuel tank - general information.
12. In case of need remove assembly (and) the fuel consumption gasoline pump/sensor (see. Section Removal and installation of the fuel pump).
13. Installation is made upside-down.

For the purpose of simplification of landing of a hose of a jellied mouth of a tank grease a reception branch pipe with pure impellent oil.