The device, service, Nissan Maxima QX repair - Removal and RSM installation//Maxim's Nissan (from 1993 g) accessories-sale.ru

Nissan Maxima QX

since 1993 of release

Repair and car operation



Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
- Control systems of the engine
   General information
   System of onboard diagnostics (OBD) - a principle of functioning and codes of malfunctions
   Removal and RSM installation
   Check of serviceability of a condition, replacement and adjustment of the sensor of provision of a butterfly valve (TPS)
   Check of a condition and replacement of the sensor of measurement of weight of an air stream (MAF)
   Check of a condition and replacement of the sensor of absolute pressure in the pipeline (MAR)
   Check of a condition and replacement of the sensor of temperature of soaked-up air (IAT)
   Check of a condition and replacement of the sensor of temperature of cooling liquid of the engine (eats)
   Check of a condition and replacement of the sensor of provision of a cranked shaft (SKR)
   Check of a condition and replacement of the sensor of provision of a camshaft (SMR)
   Check of a condition and replacement of the sensor switch of pressure in system of hydrostrengthening of a wheel (PSP)
   Check of a condition and replacement of the oxygen sensor (l-probe)
   Check of a condition and replacement of the sensor of a detonation
   Check of a condition and replacement of the sensor of temperature of fuel of speed of movement of the car (VSS)
   Check of a condition and replacement of the sensor of speed of movement of the car (VSS)
   Check of a condition and replacement of components of system of stabilization of turns of idling
   Control system of functioning of the capacity valve
   System of operated ventilation of a case (PCV)
   System of a retsirkulyatsiya of the fulfilled gases (EGR) - the general information, check of a condition and replacement of components
   System of catching of fuel evaporations (EVAP) - the general information, check of a condition and replacement of components
   The catalytic converter - the general information, check of a condition and replacement
+ Transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
9a1e70e9



Removal and RSM installation

 PERFORMANCE ORDER

 Models of cars considered in the real Management are equipped with system of additional safety (SRS). Before starting performance of any works near the block of a safety cushion, a steering column or the dashboard, disconnect SRS in order to avoid receiving traumas at its casual operation (see. Head Onboard electric equipment). Electroconducting of a chain of SRS is easy for distinguishing on yellow color of isolation.

 In order to avoid RSM damage by the electrostatic category, try not to touch contact plugs of the module. Whenever possible make self-grounding.

Each time at shutdown of the storage battery occurs cancellation of working parameters from memory of RSM that can lead to violation of stability of turns of the engine in the first some minutes after implementation of the first start.


1. The module of management of RSM is placed in assembly of the central console of the car, to the right of a gas pedal.
2. Disconnect a negative wire from the battery.

 If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for equipment introduction in action!

3. Remove panels of lateral furnish in front of the central console.

4. Disconnect electroconducting from RSM.

5. Turn out bolts of fastening of a basic arm of the module of management.

6. Carefully take module assembly from under the dashboard.
7. Installation is made upside-down.