Nissan Maxima QX

since 1993 of release

Repair and car operation



Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
- Transmission
   - 5-step manual box of gear shifting (RKPP)
      General information
      Removal and installation of components of a drive of gear shifting
      Replacement of epiploons
      Check and replacement of the sensor switch of fires of a backing
      Removal and RKPP installation
      Major maintenance of RKPP
   + 4-step automatic transmission (AT)
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





9a1e70e9



Replacement of epiploons

Leakages of transmission oil appear connected with wear or mechanical damage of epiploons or sealing rings more often. Replacement of these sealing adaptations is made rather simply and does not demand removal of transmission from the car.

Epiploons of power shafts

 PERFORMANCE ORDER

1. Epiploons are located from both parties of a case of a transmission in introduction places in them power shafts. To Poddomkratta the car also establish it on props. A sign of leakage of oil through an epiploon are begin to flow on walls of a case of RKPP directly under the corresponding power shaft.
2. Remove a power shaft (ы) (see. Head Coupling and power shafts).

3. By means of the special tool, mount or a big screw-driver with a flat sting take an old epiploon from the landing nest in a transmission case.

4. Having used as an opravka a face head of the corresponding size or a piece of a pipe of suitable diameter, plant a new epiploon on the regular place. Track, that the epiploon appeared is planted in a nest strictly perpendicularly and on full depth.

 Opravka should rest only against the firm external region of a face surface of an epiploon.

5. Grease epiploon sponges with transmission oil.
6. Establish into place a power shaft (ы), - try not to damage sponges of a new epiploon (ов).

Sealing ring of landing of the sensor of speed (assembly of a drive of a speedometer)

 PERFORMANCE ORDER

1. The sensor of speed of the car (VSS) is fixed on RKPP case. Examine a case on existence of traces of leakages of oil through a sealing ring of landing of sensor/assembly of a drive of a speedometer.

2. Disconnect from VSS electroconducting, then give clamping a bolt and take assembly of a drive of a speedometer assembled with the sensor from a transmission.
3. By means of a chertilka or a screw-driver with a thin sting remove from the removed assembly a sealing ring (best of all to use the adaptation in the form of the thin core bent on the end).
4. Plant a new sealing ring in a reception flute on a casing of a driving gear wheel of a speedometer, previously having slightly greased it with transmission oil.
5. Installation is made upside-down.

Epiploon of a rod of management of a drive of gear shifting

 PERFORMANCE ORDER

1. To Poddomkratta the car also establish it on props.
2. Disconnect a rod of management of gear shifting from a bifurcate collar (see. Section Removal and installation of components of a drive of gear shifting).
3. Beat out a cylindrical pin and remove a bifurcate collar and a dustproof cover.

4. Take from the landing nest an epiploon of a rod of management.

5. Plant to the place of removed a new epiploon.

6. Establish into place a boot and a connecting bifurcate collar, fix the last a cylindrical pin.

7. Connect a management rod (see. Section Removal and installation of components of a drive of gear shifting).
8. Lower the car on the earth.