Nissan Maxima QX

since 1993 of release

Repair and car operation



Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
- Transmission
   + 5-step manual box of gear shifting (RKPP)
   - 4-step automatic transmission (AT)
      General information
      Problem diagnostics AT/CVT - the general information
      Check, adjustment and replacement of a cable of gear shifting
      Removal and installation of the lever of the AT selector
      System of blocking of switching of transmission - the general information, check of a condition and replacement of components
      Check, replacement and adjustment of the sensor switch of permission of start
      Removal and installation of automatic transmission
      Major maintenance of AT
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





9a1e70e9



Check, adjustment and replacement of a cable of gear shifting

CHECK

 PERFORMANCE ORDER

Transfer the selector lever from the situation "R" to situation "1", - when passing each of ranges click of the corresponding clamp should be felt. If clamps do not work, or indications of the indicator of position of the lever do not correspond to really chosen AT mode, make adjustment of a driving cable of management by transmission switching.

ADJUSTMENT

 PERFORMANCE ORDER

1. Transfer the selector lever to the situation "R".
2. To Poddomkratta the car also establish it on props.

3. On models 1993 and 1994 of вып. weaken lock-nuts of fastening of a cable to a switching rod. On models since 1995 вып. weaken a lock-nut of fastening of a cable on the lever of manual gear shifting. Transfer the manual lever to the situation "R".

4. On models 1993 and 1994 of вып. tighten a back lock-nut so that it nestled on a switching rod (not strongly - to a choice of a weak point of a cable), then tighten a forward lock-nut. On models since 1995 вып. delay a cable down and, holding him and the manual lever in this situation, tighten a lock-nut.

5. Transfer the selector lever from the situation "R" to situation "1". Make sure of smoothness of a course of the lever.
6. Lower the car on the earth.

REPLACEMENT

 PERFORMANCE ORDER

 Some from models considered in the real Management are equipped with safety cushions, - without fail disconnect SRS at service of the components located near pillows (see. Head Onboard electric equipment).

1. Remove the central console and facing of the central section of the dashboard (see. Head Body).
2. Remove the handle from the AT selector lever.

3. Remove the display panel of the index of provision of transmission.

4. Disconnect a driving cable from the selector lever.

5. Liberate a cable from the basis of lever assembly.

6. To Poddomkratta the car also establish it on props.
7. Disconnect a cable from the lever of manual switching on transmission. On models 1993 and 1994 of вып. the cable fastens by means of a clip, - on models since 1995 вып. the nut is used.

8. Remove With-shaped cable fastenings in a basic arm on a transmission case. Liberate a cable from an arm.

9. Installation is made upside-down. Do not forget to adjust a cable (see above).