|
Some from models considered in the real Management are equipped with safety cushions, - without fail disconnect SRS at service of the components located near pillows (see. Head Onboard electric equipment). |
1. Execute procedures of paragraphs with 8 on 12 Sections Check, adjustment and replacement of a cable of gear shifting. 2. Disconnect a cable of a drive of blocking of a key from the electromagnetic valve of blocking of switching and liberate it from a basic arm in a forward part of the basis of the lever of the selector (see. The section System of blocking of switching of transmission - the general information, check of a condition and replacement of components).
|
3. Give two forward nuts of fastening of assembly of the lever of the selector. |
4. To Poddomkratta the car also establish it on props. 5. From below give two back nuts of fastening of the lever of the selector to a floor. 6. In salon of the car disconnect all electroconducting which can prevent dismantle of lever assembly, then separate the last from the panel of a floor and remove it from the car. 7. Installation is made upside-down. Do not forget to adjust a driving cable (see. Section Check, adjustment and replacement of a cable of gear shifting). |