Nissan Maxima QX

since 1993 of release

Repair and car operation



Nissan Maxima QX
+ Nissan Maxima brand Cars
+ Maintenance instruction
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Control systems of the engine
- Transmission
   + 5-step manual box of gear shifting (RKPP)
   - 4-step automatic transmission (AT)
      General information
      Problem diagnostics AT/CVT - the general information
      Check, adjustment and replacement of a cable of gear shifting
      Removal and installation of the lever of the AT selector
      System of blocking of switching of transmission - the general information, check of a condition and replacement of components
      Check, replacement and adjustment of the sensor switch of permission of start
      Removal and installation of automatic transmission
      Major maintenance of AT
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





9a1e70e9



System of blocking of switching of transmission - the general information, check of a condition and replacement of components

 Some from models considered in the real Management are equipped with safety cushions, - without fail disconnect SRS at service of the components located near pillows (see. Head Onboard electric equipment).


General information

The system of blocking of switching prevents possibility of a conclusion of the lever of the selector from the provisions "R" and N” without preliminary squeezing of a pedal of a foot brake. Except for described below the elementary checks, performance of problem diagnostics of system should be entrusted to specialists of car-care center.

CHECK

 PERFORMANCE ORDER

1. Remove the central console (see. Head Body).
2. Walk on an electroconducting plait from the electromagnetic valve of blocking of switching to the contact socket and disunite the last. By means of pair of wires crossing points submit tension of the battery of the plug of the electromagnetic valve, - clearly distinguishable click should be distributed.

 Do not leave the valve under tension more long, than it is really necessary for check!

3. The faulty electromagnetic valve is subject to replacement.

Replacement of components

Electromagnetic valve of blocking of switching

 PERFORMANCE ORDER

1. Remove the central console (see. Head Body).
2.Снимите the indicator of provision of the chosen AT mode.
3. Disconnect electroconducting from the electromagnetic valve of blocking of switching. Having passed a thin core in a forward part of the socket, wring out lock uvulas and disunite the socket.
4. Turn out fixing screws and remove assembly of the electromagnetic valve.
5. Installation is made upside-down.

Driving cable of blocking of a key

 PERFORMANCE ORDER

1. For replacement of the torn-off cable of a drive of blocking of a key it is necessary to remove covers of a casing of a steering column and the central console (see. Head Body).
2. Remove from the lock cylinder a lock plate, then liberate from assembly the top tip of a driving cable.

3. Liberate a cover of a cable of blocking of a key from an arm in the lower part of the lever of the selector. Remove a clamp and disconnect a cable from the lever.

4. Liberate ползун from the holder of a regulator and remove a rod of blocking of a key; at rod introduction in the holder of a regulator of a new cable it is necessary to push it before click.

5. Further installation is made as it should be the return to an order of dismantle of components.